Do not change this setting while the print job is displayed in the print wait list. Otherwise, characters may be omitted or the layout may become corrupt. Ink Drying Wait Time You can set the length of the printer rest time until printing of the next page begins. Deskripsi Produk. Resetter / Reseter Canon G1000 G2000 G3000 Service Tool V4905 ST4905 Bisa digunakan berkali-kali / UNLIMITED untuk 1 pc / computer PERHATIAN..!! untuk reset printer Canon, pastikan printer bisa masuk safe mode / service mode. - untuk memperCEPAT proses kirim file, tambahkan nomor WA di catatan saat pembelian (file hanya bisa Depending on the installation and what backup device is being used that could be a yes or it could be a no. Simply having a magnetometer in the airplane in itself doesn't guarantee the answer, because it needs to be independent of the main flight system as well as having it's own remote magnetometer and backup battery (i.e. G5, GI275, Mid First, hold down the Stop button. While holding down the Stop button, hold down the Power button. While still holding down the Power button, push the Stop button five times. Release the Power button. The printer will now be in Service Mode. Go to: No Ink Comes Out. Check1 Check the remaining ink level. Check2 Are print head nozzles clogged? Print the nozzle check pattern to determine whether the ink ejects properly from the print head nozzles. For details on printing the nozzle check pattern, print head cleaning, and print head deep cleaning, see If Printing Is Faint or Uneven. After Solution. Check the remaining ink level, and then refill the ink tank if necessary. Turn off the printer and unplug it. Wait about 30 seconds however no longer than 1 minute. Plug in the printer again and turn it back on. If the ink tank is refilled because it runs out of ink, perform system cleaning. If the steps provided do not resolve this Here is the procedure from the MG5220 service manual: i. With the machine power turned off, while pressing the Stop button, press and hold the ON button. (DO NOT release the buttons.) ii. When the Power LED lights in green, while holding the ON button, release the Stop button. (DO NOT release the ON button.) While holding the Power button, press and release the Resume/Cancel button 5 times, and then release the Power button. (Each time the Resume/Cancel button is pressed, the Alarm and Power LEDs light alternately, Alarm in orange and Power in green, starting with Alarm LED.) iv. When the Power LED lights steadily in green, the printer is ready for XamB.